With the development of society, almost every household now has its own car. Although this is a good thing, you will find that traffic accidents are increasing. In particular, some immoral people will scam, known as "porcelain bumping". It is clear that the driver didn't hit him at all, but he fell to the ground directly, crying for help. He had to blackmail a large sum of money before he would leave. What's more, he went straight to the hospital. At this time, the person who was blackmailed cannot explain clearly. And if people have driving recorder installed in their cars, these problems with porcelain can be easily solved. That is why we must install a driving recorder. However, there are some tips to buy a driving recorder. For example, you should pay attention to the length of the power cord of it. After all, we need to consider where to connect the wires. If it's from the front row, three meters is generally enough. If it's from the back row, four meters is needed. In addition, memory cards are also necessary. The rest is about how to install and route the driving recorder. That is very simple. After reading this article, you will understand!

First of all, it is necessary to make clear where the driving recorder needs to be installed. It is recommended to install on the inside rear-view mirror, and it needs to be close to the right side. This position will be clear to shoot and there will be no obstruction. Of course, it will not block the view of the driver. In addition, if the car has its own light sensor, it should be careful not to be blocked. You should remember to clean the glass before installing the dash cam. If there is dust, the suction cup will not be firm enough and easy to fall.

How to wire the driving recorder? It is recommended to plug the power cord between the gaps in the ceiling. Usually most cars can be plugged in. Then complete the wiring between the ceiling and the interior trim panel, and then pass the door frame rubber strip to the glove box, and then plug the other end of the power cord into the cigarette lighter position. If you find that the wire is too long, you can bundle the wire and fix it with adhesive tape.

We should also note that do not put the wire at the slide rail under the seat. Because the seat needs to move and it is easy to break the wire.  In addition, the power cord should not be exposed as much as possible. You can choose some gaps in the car to hide the power cord. Not only is it safe, it will also look more beautiful.

Finally, after completing wearing, I suggest that you should check whether the front of the car is in one-third of the driving recorder. This position is the best. You can see the front and both sides of the car at the same time.

Seeing here, everyone should learn how to install and wire the driving recorder. In fact, it is also very simple after mastering it.